Header1200x385

× Welcome to the CPL HPL question and answer forum. Please feel free to post your questions but more importantly also suggest answers for your forum colleagues. Bob himself or one of the other tutors will get to your question as soon as we can.

CPL- HPL

  • barbz_dee
  • Topic Author

barbz_dee created the topic: CPL- HPL

Bula,
For SCUBA DIVING, where decompression stops are needed. there are limited hours to rest before flying. These conditions only applies for:
A. cabin altitude of 10,000 ft and above
B. cabin altitude of 14,000 ft and above
C. unpressurized a/c only
D. pressurized a/c only
E. any aircraft
#1

Please Log in or Create an account to join the conversation.

  • John.Heddles
  • Offline
  • ATPL/consulting aero engineer
  • Posts: 891
  • Thank you received: 115

John.Heddles replied the topic: CPL- HPL

Discussed previously here .. www.bobtait.com.au/forum/general-enquiri...56-scuba-diving#7728

Basically, he (or she) who pushes his (or her) luck post diving .. is taking a good risk of severe pain and, perhaps, organ damage.

CASA finally is putting some words into print on the subject - see the following references for the present information.

www.casa.gov.au/standard-page/references-pexo-exams and

www.casa.gov.au/aircraft/standard-page/p...r-safety-information

So far as your question is concerned, a pressurised aircraft is only so so long as the pressurisation kit and pressure vessel function properly. For the concern, treated any aircraft as being (potentially) unpressurised.

Engineering specialist in aircraft performance and weight control.
#2

Please Log in or Create an account to join the conversation.

  • Posts: 2477
  • Thank you received: 266

bobtait replied the topic: CPL- HPL

Thanks John, very helpful references. Also, even if the aircraft pressurisation system is operating normally, decompression sickness (the bends) has been found to occur as low as 8000ft, which is close to the cabin altitude in most pressurised aircraft.
#3

Please Log in or Create an account to join the conversation.

Time to create page: 0.099 seconds